Osha Edge Of Roof Requirements

Between 6 feet and 15 feet from the roof edge.

Osha edge of roof requirements. Osha regulations for commercial roof inspections. Your letter proposes to place the control lines 10 feet off the leading edge. The best solution and the simplest is to install roof edge guard railing around the trouble spots to eliminate the fall hazard completely. Section 1926 501 b 10 sets out the fall protection requirement for roofing work on low slope roofs.

If you choose to walk on a roof without these you will be out of compliance with osha regulations and subject to fines. Between 6 feet and 15 feet from the edge. Conventional fall protection guardrail fall restraint or. Each employee working on at above or near wall openings including those with chutes attached where the outside bottom edge of the wall opening is 6 feet 1 8 m or more above lower levels and the inside bottom edge of the wall opening is less than 39 inches 1 0 m above the walking working surface shall be protected from falling by the use of a guardrail system a safety net system or a personal fall arrest system.

The new rule provides some clarification to this despite osha s previous stance that there is no safe distance. As stated in the standard control lines must be between 6 feet and 25 feet from the leading edge. Unprotected sides and edges. The occupational safety and health administration has set new guidelines for inspecting commercial roofs.

Employers are to ensure. For general industry working at a 4 foot height or a low sloped roof osha requires. 6 feet from the edge. Because 10 feet falls within the range stated in the standard control lines placed 10 feet off tie leading edge comply with 1926 502 g l i.

Is there a safe distance from the edge of a roof for construction workers doing work while on a roof but not engaged in roofing residential pre cast erection or leading edge work. Osha standards frequently cited during fy 2013 inspections of roofing contractors naics 238160 rank by number of citations issued categories standard 1 duty to have fall protection 1926 501 2 ladder safety 1926 1053 3 fall protection training requirements 1926 503 4 eye and face protection 1926 102 5 general scaffold requirements 1926 451 6. Osha requires that workers exposed to a fall hazard must have fall protection. Less than 6 feet from the roof edge.

Employers are to ensure that each employee is protected from falling by using fall. Industry standard says that protection must be in place for anyone working within 15 feet of the roof edge. Answer background in 29 cfr part 1926 subpart m fall protection 1926 501 b 1 states. Under that section an employer may use a combination of warning lines 6 feet and in some cases 10 feet back from the edge in combination with monitors in place of personal fall protection equipment or guardrails.

These include using roof anchors and safety cords for roof inspections. Conventional fall protection guardrail fall restraint or fall arrest system is required.